The 1990 Buick 3800 was a car my father purchased 10 years before his death and I have repainted and restored it to like new and drive it daily. Problem is the cam sensor I have replaced 3 times.
Been having a problem with my 2000 Buick regal supercahrged. It has been dying while i am driving and when it happens it usually starts right back up. When it dies only the accelerator and power steering is effected.
It stalls on very low speed deceleration and restarts immediately..Spark test done and diagnostic scan with no codes expressed. Can the MAF, Crankshaft, Throttle sensors the ICM give false negatives when scanned?.
no power to ac compressor. I put a paper clip in wire for low pressure and it has power. Got climate control on auto 60 but there is no power to compressor the auto light is on. I checked the fuses and relay all good.
What are some common causes for the EVAP emissions codes that turned on the check engine light.
Could you please look at the pressure test results i got after testing the transmission with my Tech II?
My car has a multi link independent rear suspension, and when ever i take a corner and hit a small bump at the same time the car moves or sways over the rear wheels, not up and down but side to side like something is loose.
My dash display goes dim or completely dark at times. How can i fix this problem on my Buick?
A/C compressor, orifice tube and drier replaced about 1 year ago. The problem I have is that when you turn the ac on the cool air only comes out the 2 vents on the passenger side. The 2 vents on the drivers side have warm air blowing out.
what should be checked first? The service engine light cam sensor was bad and replaced with ac Delco. Light came back on with in 10 miles. took it back was told crank sensor may be bad or may have a bad pcm. Where would be a good place to start?
I have a 1991 park ave. I only paid $800 for it and put a ton into it; brakes and lines, power steering pump, alternator, coil pack, ignition.
my car never ran hot or gave me any problems one day it started riding funny so i pulled over and turned the car off when i lifted up the hood it was no water in it and there was no sign of leakage(water was in it a couple days prior).I put water in it, but then it wouldn't crank. Please tell me what could this possibly be??.
The dash panel lights are all out, except when I first start my car. Then all the warning lights will flash just for a second. Afterwards, everything goes dark. Subsequently, my tail lights don't work whenever the panel lights are out. I would be extremely grateful if you can answer this, because everyone keeps giving me the run around. I've already gotten a ticket for this, and I am a struggling mommy. I honestly would donate.
04 Buick Lesabre shifts rough sometimes from 1st to 2nd feels like a slight shudder, been told need another transmission. Had it flushed, has helped some. Has 225 60r16 tires when door panel says 215 70r 15 tires. Some models came with the 225 option. I was wondering does or can computer shift points need to be changed, I've heard with different tires computer needs to be reset or it throws shifts, speedometer and odometer off.
1 i have a 1997 buick lesabre replaced the head gaskets and up it started just fine. Just needed to jump battery. Ran and got code random misfire and random misfire cylinder #6. Replaced ign. coils and replaced battery now wont start. It cranks just fine getting fuel and getting spark. It wants to start but wont, any ideas out there.
Battery was replaced now he can't get the radio to go back on. He did the code this and came up with the numbers. Can you help with instructions on how to enter the code and also help me find....
The transmission is slipping on my car. The engine revs up between gears. Does this mean i need a new one or can it be repaired?
Doesn't matter what gear its in or anything. Have to disconnect the battery to shut off the lights. I know its a short somewhere, but is it possible that the steering is jacked up or is there a switch?
How can i determine which wheel bearing hub is bad and making the noise. Also can I replace myself.
Had the A/C compressor and orifice tube replaced last year, now the passenger side vents are cool, but drivers side blows warm air all the time no matter where I put the HVAC controls.
Car will not start or turn over. All the lights on dash will flash. The ignition switch ands starter has been replaced.
A mechanic replaced the PCM on my Buick, it started and ran fine, but now won't start again. Why does the computer keep going bad?
My truck won't crank sometimes when I turn the key. The security light is on. Also the interior lights will go on and off when i am driving.
Why does the oil pan leak on the floor in my car? How do I fix this problem?
My 1999 Regal will not start. I turn the key and nothing happens. Is this problem the Passkey cylinder or the ignition switch?
My car wont start. I did a computer scan but there are no codes. Would a bad ignition coil cause this problem?
When i press the brake pedal, there is sort of a woosh sound. We replaced the master cylinder and the ABS light is on.
My car was leaking antifreeze from the intake manifold gasket. My mechanic replaced the gasket and plenum. He also replaced the PCV valve and replaced the oil pan gasket which was slowly leaking. He flushed and filled the radiator, replaced all the oil and filter.
Changed fluid and filter on 1995 Lesabre.
I have trans shifting problems on my Buick.
Air from vents is hot passenger side.
Then they come back on. Replaced VSS vehicle speed sensor and wires.
The Mass airflow sensor and 02 were replaced.
we replaced it and the heated seat switch in door panel.
Why does my ABS light come on. Can i fix this myself?
Had Codes scanned and got C1216. Is this a common problem we can repair?
1999 Buick LESABRE. CUSTOMER COMPLAINS OF a noise in the right front of his car.
Several electrical problems. Fuses where checked.
Poor shifting from first to second and third gear 2004 Buick Lesabre.
How do i check and repair this problem..
The fluid level is good. What else could be the problem?
Has there been any work been done to repair this condition?
2000 Century with the 3.1 v6. Need step by step instructions.
Is this a transmission or catalytic converter problems?
Cam shaft sensor replaced. What to look for next.
Battery was replaced but did not help to get it started.
and the codes come up p2761, and p0748. Also it does not start sometimes.
Need repair help. Is there a possible TSB?
The security light is flashing and now it wont start.