Camaro 1994 3.4 24x sensor

[Tauras]

Hello, i have 1994 camaro v6. It starts and then after couple or more seconds (or if i press gas pedal) shuts off. Obd1 diagnostic shows 36 code for 24x crank sensor. I tried to test it with multimeter and it will not show any signs of life. All wires are good, sensor gets 12v ground and signal wire to pcm is okay also. I changed pcm and nothing changed. Changed crank sensor and nothing. Then i tried to put a3144 hall efect sensor but still no change. If you have any clue whats wrong please help!

[carriedi]

If you have a DVOM that has graphing capabilities you can check the 24x signal. hook up to the ckp(24X) wire and the other lead on the meter to a good ground. The three wire connector middle wire should be the 24x signal wire. light blue/white wire out of the crank sensor. Disable the fuel system so the engine won't start and watch the meter while cranking the engine.

here is a flow chart for checking for code 36 24x code.

[guest]

hi i have a 96 camaro 3.8 just bought it has a skip when i short out cyl with test light first cyl passenger side does not make much of a difference all the rest do .checked comp 145 changed spark plugs ,wires eng mod. and coils . no change . now the last coil has no spark at all changed it and no difference dont know where to go from here i guess i have been getting bad advice thank you for the time to Lisson to me

[carriedi]

first of all, does your car have a miss that you are trying to find?