1998 LeSabre no start no codes

Buick Regal, Century and Park Avenue as well as the Rendezvous and Lesabre.
Ask our auto mechanics for help to all your Buick questions now.
Posts: 1
Joined: Wed Dec 05, 2012 11:52 am

1998 LeSabre no start no codes

Unread post by jimvee » Wed Dec 05, 2012 11:58 am

1998 Buick LeSabre, 3800 eng. No start, original problem began with check eng light, now cranks well but no start. Checked codes with scanner, no codes present. Code reader does activate and seems to do a scan. Is ECM bad? would a defective coil leave a code?

User avatar
Posts: 652
Joined: Wed Oct 17, 2012 10:08 am

Re: 1998 LeSabre no start no codes

Unread post by ProTech » Thu Dec 06, 2012 7:19 pm

If the vehicle cranks, I'd bet the ECM is ok since it controls the starter relay, and I've never seen a whole bunch of problems with the computers the LeSabre's.

I would probably start off by doing some basic checks, since you know it cranks ok. Two basics you should get out of the way first would be to check for spark and to check fuel pressure. You can either remove a spark plug wire from the coil or plug itself and check spark there while someone cranks the car over. If you have spark, you can assume that you have a good ignition module and crank sensor.

A fuel pressure check can be taken right off the fuel rail if you have a gauge. It should be at least 48-55psi with the key on and hold steady. If it less than 45psi or the pressure drops off right away, you probably have a bad fuel pump. Also, check the fuel pressure regulator for leaks too if the pressure drops off, but that won't usually cause a no start condition.

You might also want to just verify there are no trouble codes set by doing a scan one more time. You don't want to overlook anything. If both the spark and fuel check out, then you could be looking at a wiring problem, a sensor that is shorted out, or lastly and least likely a bad ECM.
GM Dealer Technician For 18+ Years
In the automotive industry for 20+

Post A Reply

  • Similar Topics
    Last post