rr brake & turn signal dont work
Re: rr brake & turn signal dont work
check the BCM fuses in the underhood fuse box
Re: rr brake & turn signal dont work
BCM6 FUSE GUEST LABELING IT A RT TURN SIGNAL FUSE WOULD HAD BEEN TOO NORMAL AND MADE IT TOO EASY TO FIND? WEIRD...
Re: rr brake & turn signal dont work
My van is left rear and left turn signal not working. 2009
On my 2008 Chevy Express van I have no turn signals or brake light on the left side
I have no turn signal or brake light on left side
Re: rr brake & turn signal dont work
Changed bulbs didn’t work. Checked BCM 6 bad fuse. Which BCM is it if the left side goes out?
Re: rr brake & turn signal dont work
Bigblocknut: check the LR STOP/TURN fuse (fuse 4) 10A in the fuse box under the left front seat. If the fuse is good, verify that the yellow wire from the turn signal/hazard module is sending a power signal to the fuse. If there is not power signal to flash on the yellow wire you have to check the power and grounds to the turn/hazard module.
check the DR TRN MIR fuse 14 (10A) in the fuse box below left front seat.
check the DR TRN MIR fuse 14 (10A) in the fuse box below left front seat.
Re: rr brake & turn signal dont work
Bigblocknut wrote: ↑Fri Sep 29, 2017 3:49 pmHello everyone one I'm first time user here so hope I'm doing everything right. I have a 2004 chevy express 3500 van and having a similar problem as one previously posted with signal and tidal light issues but I've checked fuses under hood and seat and all seam to be good . I see where there was talked about the BCM or there fuses and snot sure on the BCM itself being a issue or there's fuses as I checked them and all seem good. The problem started after I hooked LED. Lights up on my trailer and they all worked good but I did have to scratch around and clean the contacts on the trailer light plug was very dirty but after I did get them working and I noticed after everything was done I had no driver side rear signal or driver side brake light and the front signal blinks really fast. Any help or advice would be greatly appreciated. Thanks
Re: rr brake & turn signal dont work
do you have a test light? If you do, you can check the LR STOP?TURN (fuse 4) in the fuse block under the driver's seat. With the key in the run position (or with the engine running) turn on the suspect turn signal. with the signal flashing in the front, is the #4 fuse blinking the test light? If it's blinking then you need to look at the wiring going to the tail light assembly or the light assembly itself. If it is not blinking then you need to check the Yellow wire coming out of the turn signal flasher module. Is the yellow wire right out of the flasher module blinking? If not you probably need a flasher module. The turn switch sends the signal to the module. The module uses the signal to power up both the front and rear lights. So, it should be sending out the turn signal to both the Yellow wire to the rear and the light blue wire that goes to the left front.
The turn module is located behind left center of the dash.
The turn module is located behind left center of the dash.
-
- Similar Topics
- Replies
- Views
- Last post
-
-
New post 1993 Mercury Cougar XR-7 Turn Signal & Brake Light Issues?
by 1964prostreetelcamino » Tue Jul 15, 2014 4:32 pm » in Ford Cars - 1 Replies
- 7076 Views
-
Last post by carriedi
Tue Jul 15, 2014 6:07 pm
-
-
-
New post Gmc envoy wont restart gauges dont work
by Jodie » Thu May 11, 2017 2:53 pm » in GMC Trucks - 3 Replies
- 10781 Views
-
Last post by carriedi
Wed Feb 07, 2018 1:35 am
-
-
-
New post driver side headlights dont work. wiring problem i think
by Joshp » Tue Oct 06, 2015 10:18 pm » in Chevy Trucks - 1 Replies
- 8868 Views
-
Last post by carriedi
Wed Oct 07, 2015 11:20 pm
-
-
- 1 Replies
- 1155 Views
-
Last post by carriedi
Sun Oct 17, 2021 4:27 am
-
- 3 Replies
- 6697 Views
-
Last post by carriedi
Thu Jan 08, 2015 3:33 am