Stubborn Dodge Caravan ignition lock cylinder
-
- Posts: 1
- Joined: Tue Mar 03, 2015 3:26 pm
Stubborn Dodge Caravan ignition lock cylinder
Is there any way to free-up an intermittently-stubborn ignition lock cylinder? Steering wheel is not locked, it is in Park, the thing senses that the door is open with a key in the ign., but key will not turn to start engine. Sometimes when it does this I'll jiggle the key &/or jab it in a little harder and it will turn and start. I have used WD-40 and graphite(worked once). Any ideas?
Re: Stubborn Dodge Caravan ignition lock cylinder
The key has a series of cuts in the key. when you insert the key into the lock, it runs through a bunch of spring loaded tumblers that follow the edge of the key. When the key is all the way in and all the tumblers match the cuts in the key, it allows you to turn the ignition switch. Every time you insert the key it wears a little bit. the Key wears and the tumblers wear. After a while the sharp points on the key are gone. The straight cuts on the tumblers start to get oval. Eventually, the tumblers won't match up to what the lock requires so you can turn the lock.
You could try another key, if you have one, that is not worn down as much. you can have the lock tumblers replaced and a new key cut with the same settings. you can get a new lock and tumbler assembly. ( a new replacement lock and tumbler will come with new keys that probably won't match your doors so you will still need your old key for the doors and the new keys for the ignition)
You could try another key, if you have one, that is not worn down as much. you can have the lock tumblers replaced and a new key cut with the same settings. you can get a new lock and tumbler assembly. ( a new replacement lock and tumbler will come with new keys that probably won't match your doors so you will still need your old key for the doors and the new keys for the ignition)
Re: Stubborn Dodge Caravan ignition lock cylinder
This is what works for me, I tap the end of the key gently but firmly with my "window breaking safety hammer" or you could use a regular hammer very gently, it works every time. I need a new ignition but the van is old and has well over 200000 on it so...........
-
- Posts: 1
- Joined: Sat Jul 11, 2015 11:45 pm
Re: Stubborn Dodge Caravan ignition lock cylinder
93 dodge 1 ton 4wd. after sitting for 8 days unused in rainy weather, it now wont start. The "wait to start" light and others on dash don't come on. with key in run position, the only thing that works is the windows(dome and headlights work, and don't dim when working windows). turn signals don't work(but hazards do). really, nothing happens when key is turned-no clicking. do I change the obvious ignition switch, or is there anything else to check first. never gave hint of a problem before.
Re: Stubborn Dodge Caravan ignition lock cylinder
I would check out the power to your ignition switch.
check for power on the big red wire at the ignition switch. If gets it's power from the orange fusible link under the hood. many times the fusible will burn out and shut down power to the ignition switch. The insulation might still be intact but if you pull on the orange fusible link and stretches then it's burned up inside the insulation. Cut it out and replace with a new piece of fusible link. DON'T USE REGULAR WIRE. USE FUSIBLE LINK TO PREVENT A POSSIBLE FIRE.
check for power on the big red wire at the ignition switch. If gets it's power from the orange fusible link under the hood. many times the fusible will burn out and shut down power to the ignition switch. The insulation might still be intact but if you pull on the orange fusible link and stretches then it's burned up inside the insulation. Cut it out and replace with a new piece of fusible link. DON'T USE REGULAR WIRE. USE FUSIBLE LINK TO PREVENT A POSSIBLE FIRE.
Re: Stubborn Dodge Caravan ignition lock cylinder
Run, don't walk to your nearest O'reilly, Autozone, etc and get a replacement cylinder for that thing! Otherwise it's going to lock up on you one day and then you'll either need a locksmith or to destroy the cylinder to get it out. With it working it's easy. Take the steering column covers off and follow the instructions included with the cylinder. You'll end up with a different key but that much easier that dealing with the high cost of a locksmith. Or you could take the cylinder out and to a locksmith and have him rebuild it to fit the key code your van came with. More expensive that a new lock cylinder but still cheaper than a service call.
Re: Stubborn Dodge Caravan ignition lock cylinder
There is no problem in the ignition switch according to me replace the ignition cylinder and get the problem resolved.
Re: Stubborn Dodge Caravan ignition lock cylinder
right on DanielChandler. Glad you got yours fixed. some people needed a lock cylinder. All it does is turn the ignition switch and lock the steering wheel. Others had a lock and tumbler that worked but some things didn't turn on. they needed to check the electrical part of the starting mechanism.
what we all want is to just turn the key and be able to drive to where we want to go. Gotta love that.
what we all want is to just turn the key and be able to drive to where we want to go. Gotta love that.
-
- Similar Topics
- Replies
- Views
- Last post
-
- 9 Replies
- 22126 Views
-
Last post by carriedi
Mon Apr 17, 2023 6:08 am
-
- 10 Replies
- 34681 Views
-
Last post by dw85745
Sat Feb 20, 2016 8:44 am
-
-
New post Dodge Grand Caravan engine does not start
by gmeades » Mon Sep 04, 2017 8:47 pm » in Dodge And Chrysler - 3 Replies
- 27002 Views
-
Last post by carriedi
Wed Jun 13, 2018 12:33 am
-
-
-
New post 2014 Grand Caravan Radio doesnt work
by Yellowolf » Thu Mar 16, 2017 6:41 pm » in Dodge And Chrysler - 7 Replies
- 57093 Views
-
Last post by carriedi
Sat Jan 11, 2020 6:12 am
-
-
-
New post REMOVING LOWER DASH SECTION FROM A 2013 GRAND CARAVAN
by GUEST » Thu Jan 18, 2024 3:57 pm » in Dodge And Chrysler - 1 Replies
- 9698 Views
-
Last post by carriedi
Sat Jan 20, 2024 12:03 am
-