Chrysler over heating parts replaced

[Dillinger]

need to find the BCM on a 1997 Dodge stratus cant find it in the vehicle :(

[ProTech]

It's located under the dash, near or bolted to the inside fuse block.

[russell.pendleton2]

The camshaft seal blew clear out of the head and when i got it apart i looked into the head around the cam and whatever the seal sits flush against looks broke what is that and can it break or is it supposed to look yhat way

[ProTech]

If you can tell me the year and model of the car, and the engine size, I can help you.

[rtann47]

87 Chrysler town and country over heating.
I know the list as to why a car may over heat is very long. I have in the last year replaced the rad and hoses put in a new thermostat BUT still it over heats. While driving it today the car over heated going into the red. I turned the heater up full and very cold air came instead of hot. My ? is could my car need a new fan or maybe a water pump?

[ArronBurns]

If you have no heat in the cab and your engine is overheating than your coolant level is low or you have an airlock in the system. You may have an internal engine problem. I do not guarantee any repairs on an engine that has been overheated as the possibility of internal damage is very high. I recommend having it inspected by a professional.

[Scott21]

My 2006 chrysler 300c 5.7l start hard will idle but has no fuel pedal I've changed crankshaft position sensor throttle body pedal sensor not sure what to do next

[carriedi]

you should use a scanner and look at the throttle data. is the check engine light on? have you checked for codes?

[Scott21]

Right now my 300c is showing 3 codes p0335 p0406 &p0403 again I changed the crankshaft position sensor the throttle body & pedal sensor

[Scott21]

Just talked to chrysler dealer they said after changing these parts I have to get the computer relearned let u know how that goes

[carriedi]

yes, the pedal and throttle body should be relearned after installation. Otherwise the computer won't run normally. It wants them both sync'd up. why did you replace them? Usually when they have a problem you will have a code for that and the vehicle will run but in a very limited mode. (just barely able to get you home) (codes like a p0122,123,124 or something like that)

the codes should be cleared and see what codes return.

p0335 is for the crank sensor,
p0406 is for egr position sensor circuit high
p0403 is for egr solenoid circuit.

[dafaa45]

It wants them both sync'd up. why did you replace them???