1998 ford expedition wont crank
1998 ford expedition wont crank
the truck was running and the starter went bad I replace the starter and now the truck wont start it seemed like the starter was binding up put shims in and it was doing the same thing I replaced the starter solenoid on fire wall still same thing I tested the motor to see if it seized but the motor is fine I can turn over by hand I changed relays and all does anyone have any idea what could be the problem
Re: 1998 ford expedition wont crank
ok, first you have to give me the details. what happens when you turn the key to the start position? does the starter relay make a big click? does the starter solenoid make a big click? does the starter turn the engine over at all? if it does crank the engine, does it sound normal?
do you have good clean connections at the battery? do you have a good connection to the engine ground? do you have a test light and/or a dvom?
do you have good clean connections at the battery? do you have a good connection to the engine ground? do you have a test light and/or a dvom?
Re: 1998 ford expedition wont crank
Everything makes clicking noise the starter turns the engine a half of turn I checked all connections everything was good
Re: 1998 ford expedition wont crank
double check your battery connections or check your battery. it sounds like you aren't getting enough amp through to the starter
if you can manually turn the engine over it shouldn't be a problem for the starter to spin the engine with the battery. starter draw should be maybe 200-350 start up amps but run 100-200 cranking. Only a couple of things will make it crank over slowly. Too much drag on the motor, bad starter or not enough amp from the battery to the starter. If you can turn the engine over manually, it shouldn't be too much drag. If you put in a new starter it shouldn't be a bad starter (shouldn't be but even new starters are sometimes bad). That leaves not getting juice to the starter.
if you can manually turn the engine over it shouldn't be a problem for the starter to spin the engine with the battery. starter draw should be maybe 200-350 start up amps but run 100-200 cranking. Only a couple of things will make it crank over slowly. Too much drag on the motor, bad starter or not enough amp from the battery to the starter. If you can turn the engine over manually, it shouldn't be too much drag. If you put in a new starter it shouldn't be a bad starter (shouldn't be but even new starters are sometimes bad). That leaves not getting juice to the starter.
Re: 1998 ford expedition wont crank
Ok I will get a new battery and I will let you know what happens thanks
Re: 1998 ford expedition wont crank
can you check your battery before you go out and buy another one? Or try jumping it?
-
- Posts: 1
- Joined: Fri Sep 19, 2014 5:26 pm
98 expedition brakes going to the floor
My 98 expeditions brake light came on in the dash board and petal going to the floor. I checked fluid and its fine and brakes were replaced early may what iswrong?
Re: 98 expedition brakes going to the floor
If there is no ABS light on, I would suspect that your master cylinder is bypassing the seal for the master cylinder piston.
-
- Similar Topics
- Replies
- Views
- Last post
-
- 4 Replies
- 30633 Views
-
Last post by carriedi
Mon Dec 28, 2015 6:17 pm
-
-
New post Ford F-350 Truck Illuminated Emblems
by RogerSan » Sat Feb 10, 2018 2:14 am » in Ford Trucks - 6 Replies
- 31754 Views
-
Last post by rusgrant83
Thu Mar 01, 2018 1:33 am
-
-
- 5 Replies
- 26186 Views
-
Last post by carriedi
Wed Apr 13, 2016 1:03 am
-
-
New post 1994 ford bronco xlt 5.8 351 win no heat
by Hlovell1977 » Tue Dec 13, 2016 2:04 pm » in Ford Trucks - 1 Replies
- 23498 Views
-
Last post by carriedi
Wed Dec 14, 2016 11:18 am
-
-
-
New post 2007 ford freestyle wrench light comes on and will not shift
by farmerdawn » Sun Aug 30, 2015 8:29 pm » in Ford Cars - 7 Replies
- 30432 Views
-
Last post by carriedi
Sat Nov 18, 2017 6:04 pm
-