ford truck blower fan only works on high
Re: ford truck blower fan only works on high
yes, power into motor and resistor on all speeds.
Re: ford truck blower fan only works on high
Well that does not make sense that you have power into motor on all speeds, but only high works. I think you are going to have to find a wiring diagram and check the ground circuit for the resistor. Again, high speed does not go through the resistor.
Read some SIMILAR questions down below for more help.
Check out our Photo Gallery
Check out our Photo Gallery
Re: ford truck blower fan only works on high
the brn/orange wire should have power from the blower relay. through fuse 107 = 40a. the orange/blk wire grounds through the blower controls. High by passes the resistor. Going into the resistor is LOW grn/white, MED is yellow/red. ground is the blk wire. orange/black if fan mtr.
fan on high - blk/orange will be direct ground.
fan on medium - yellow and red will be the ground
fan on low - grn/white will be the ground.
turn heater switch to heat with the key on.
with the blower motor switch in the low position touch a fused jumper from ground to the grn/white wire at the resistor. does the fan go on low? if the fan goes on low the resistor and relay are working. you need to look at the control head. If it doesn't the resistor may be bad. they have a thermal protector like a fuse. if it gets hot it blows and it's finished. That's why they put them inside the heater box. so the blower will blow on them and keep them cool.
fan on high - blk/orange will be direct ground.
fan on medium - yellow and red will be the ground
fan on low - grn/white will be the ground.
turn heater switch to heat with the key on.
with the blower motor switch in the low position touch a fused jumper from ground to the grn/white wire at the resistor. does the fan go on low? if the fan goes on low the resistor and relay are working. you need to look at the control head. If it doesn't the resistor may be bad. they have a thermal protector like a fuse. if it gets hot it blows and it's finished. That's why they put them inside the heater box. so the blower will blow on them and keep them cool.
Browse "SIMILAR TOPICS" At The Bottom Of This Page.
-
- Similar Topics
- Replies
- Views
- Last post
-
-
New post high revs when depressing clutch - ford focus zetec 1.8 1998
by charliebrownboy » Sat Aug 23, 2014 4:09 pm » in Ford Cars - 2 Replies
- 6359 Views
-
Last post by charliebrownboy
Thu Aug 28, 2014 3:11 pm
-
-
- 1 Replies
- 5827 Views
-
Last post by carriedi
Wed Nov 26, 2014 4:08 am
-
- 1 Replies
- 16189 Views
-
Last post by carriedi
Tue Jan 23, 2018 5:59 am
-
-
New post Ford F-350 Truck Illuminated Emblems
by RogerSan » Sat Feb 10, 2018 2:14 am » in Ford Trucks - 6 Replies
- 17244 Views
-
Last post by rusgrant83
Thu Mar 01, 2018 1:33 am
-
-
-
New post 1976 Ford Truck on class C Rv "starter cylinoid info needed"
by jly » Mon Mar 30, 2015 4:25 pm » in Ford Trucks - 11 Replies
- 10713 Views
-
Last post by carriedi
Tue May 19, 2015 10:53 pm
-