Help need my baby back on the road plz help
Help need my baby back on the road plz help
Put 96 gmc 350 tbi into my 93 gmc went from v6 to the v8 changed out cam to milling #m1103 & lifters now she startd runs and drives but when gets to lowest rpm or to a good idle it just shuts off but will start right back up will tun again then will idle back down and die no way to adjust the idle on the throttle body now I am lost and bout to loos my job if I cant get this fixed need my truck for wrk right now
Re: Help need my baby back on the road plz help
did you change everything that goes with the V8 motor... ECM and stuff?
Browse "SIMILAR TOPICS" At The Bottom Of This Page.
Re: Help need my baby back on the road plz help
you can take out the idle adjust tamper cover and adjust the idle stop. the shiney silver cover close to the throttle shaft, in the picture, is covering the idle stop adjuster. If you look at where your throttle stop is, the opposite side side of the stop that sticks out of the throttle body has a cover put in the throttle body so that it can't be tampered with. However this cover can be removed and you can adjust the idle stop. If your idle is too low for your conversion.
Browse "SIMILAR TOPICS" At The Bottom Of This Page.
-
- Similar Topics
- Replies
- Views
- Last post
-
-
New post 2000 suburban back ac not working
by jessica2546 » Sun Jul 20, 2014 11:55 pm » in Chevy Suburban - 5 Replies
- 9330 Views
-
Last post by carriedi
Tue Feb 21, 2017 11:50 am
-
-
- 1 Replies
- 3796 Views
-
Last post by carriedi
Wed Sep 03, 2014 1:27 am
-
-
New post after turning on the motor,it shuts right back of
by Chavez » Thu Nov 06, 2014 5:11 pm » in Chevy Suburban - 1 Replies
- 7240 Views
-
Last post by carriedi
Thu Nov 06, 2014 6:46 pm
-
-
-
New post 97 blazer back hatch light switch
by backanforth10to2 » Fri Dec 02, 2016 6:21 pm » in GMC Trucks - 3 Replies
- 6270 Views
-
Last post by carriedi
Thu Dec 08, 2016 10:28 pm
-