95 blazer no tcc lock up

[carriedi]

I have a 95 blazer 4.3l vin code W. My TCC does not come on. I can turn it on with a scanner buty it never comes on by itself. Since I can turn it on by commanding on with the scanner wiring should be good. Trans temp runs about 175F and TPS works normally when I look at the TPS on the scanner in engine controls. Tried a rebuilt vcm (located over coolant bottle on passenger side engine compartment) Had it flashed at dealer. No help. What am I missing here? Scanner always shows TCC forced off. any ideas or has anyone had similar problems like this?

Thank for any help you can give me.

[TerryAuto]

Any trouble codes?
About the only other thing that can prevent TCC is a brake switch applied signal.

[carriedi]

no codes. Had a c1286 in ABS, (bulb was out) fixed that and cleared code. no other codes in any modules. brake switch appears to work normally. Cruise control turns on and off. Purple wire

[TerryAuto]

Hmm. Very strange. Since you can control it with scanner, then the VCM and everything past it is good. Something is inhibiting TCC. Vss signal, A/C clutch engage signal, 4wd H/L signal.

[carriedi]

as it turned out the pwm solenoid amp draw was very low. changed the solenoid and now it is working normally. I don't know why the computer didn't set a code. or why I could command the computer to turn on the solenoid and it would work. But it's all working now.