I have a 2007 Grand Prix.my center council light's don't come on.
I all ready checked the fuses .
Grand Prix 2007 center console light
Re: Grand Prix 2007 center console light
what lights are you talking about? Lights in the shift indicator if you have a console shifter? Map and dome lights if you have an overhead console? Light in the compartment of the console? and what fuse did you check to decide that it's not a fuse? What turns the lights on and off?
Browse "SIMILAR TOPICS" At The Bottom Of This Page.
-
- Posts: 2
- Joined: Sat Mar 05, 2016 11:13 am
Brake/blinker passenger side keeps failing
The tail lights on both sides working. Drivers side, all three functions work. Passenger side, only the tail light works. It's the same bulb, I think it's called a dual filament bulb. Changed it, worked a week. Changed it again, only worked for a block! I have zero extra cash for a mechanic, have to try to repair this myself. Any ideas, greatly appreciated. Thanks in advance.
Re: Brake/blinker passenger side keeps failing
Not sure what your problem is. what circuit stops working? Tail light is one circuit. It is separate from other circuits. The turn signal is another circuit but that may be tied to the brake light circuit. What is it that stops working?
you are correct that the light bulbs are the same from side to side but is it that the bulb filaments get burned out (you should be able to visually see the separate filaments) or does the bulb stop working? You could have a bad socket or a problem with the wiring.
do you have a 12 volt test light to test your light circuits?
you are correct that the light bulbs are the same from side to side but is it that the bulb filaments get burned out (you should be able to visually see the separate filaments) or does the bulb stop working? You could have a bad socket or a problem with the wiring.
do you have a 12 volt test light to test your light circuits?
Browse "SIMILAR TOPICS" At The Bottom Of This Page.
-
- Posts: 2
- Joined: Sat Mar 05, 2016 11:13 am
Re: Brake/blinker passenger side keeps failing
I know it's been a while, I was sick, and it's too cold here to do this outside. OK. The rear brake light and blinker are the same bulb as the tail light. It's a dual filament. The brake and blinker went out. The regular tail light still works. I replaced it. Drove a block, hit the brake, it went out immediately. I got an indication on the warning light panel. I'm trying to figure out why one filament in dual filament bulb would keep failing. Only one side, drivers side is fine, so it's not the thing under the brake pedal that lights up the brake lights. And it worked until I pressed the brake. Is this a bad socket maybe?
Re: Brake/blinker passenger side keeps failing
does the filament burn out or is the bulb not working? you could have a bad socket where there is a bad connection for the brake light circuit.
Browse "SIMILAR TOPICS" At The Bottom Of This Page.
-
- Similar Topics
- Replies
- Views
- Last post
-
- 5 Replies
- 11144 Views
-
Last post by carriedi
Fri Sep 30, 2016 8:37 am
-
-
New post 2007 Grand Prix, 1 out of 15, Hesitates taking off from a stop
by goodwinbj » Fri May 28, 2021 1:41 pm » in Pontiac Grand Prix - 1 Replies
- 10078 Views
-
Last post by carriedi
Fri May 28, 2021 2:22 pm
-
-
-
New post reduce power light on for a 2006 grand prix 3800 seris v6
by bigemike » Sun May 27, 2018 3:23 pm » in Pontiac Grand Prix - 3 Replies
- 13233 Views
-
Last post by OldPaul
Sun May 27, 2018 6:13 pm
-
-
- 1 Replies
- 19415 Views
-
Last post by carriedi
Mon Oct 05, 2020 4:46 am
-
- 1 Replies
- 8129 Views
-
Last post by carriedi
Sun Oct 12, 2014 1:40 am