Transmission filter change
Transmission filter change
How hard is it suppose to be to get filter to Snap in?
It did not seem to be in tight, will it stay in?
It did not seem to be in tight, will it stay in?
Re: Transmission filter change
how difficult was it to remove the old filter? Shouldn't be able to fall out by itself... what is your year make model engine size and trans?
Browse "SIMILAR TOPICS" At The Bottom Of This Page.
Re: Transmission filter change
93 New Yorker 5th Ave 3.3, and a 3.8.
It kind of snapped out but it didn't Snap going in.
I hit it with the butt of my palm, the little pegs clicked ,the round one felt not Snapped in.
It kind of snapped out but it didn't Snap going in.
I hit it with the butt of my palm, the little pegs clicked ,the round one felt not Snapped in.
Re: Transmission filter change
you put the new O-ring in right? that's what seals the tube when it gets pushed up into the filter port. You may want to lube up the O-ring before you put nit in.
Browse "SIMILAR TOPICS" At The Bottom Of This Page.
Re: Transmission filter change
I did lube it , think that it is what is holding it up.
Felt like it was too firm / fat an O- ring.
Will it fall off in the pan?
Can it hurt it ?
It seems to shift harder, ...
Felt like it was too firm / fat an O- ring.
Will it fall off in the pan?
Can it hurt it ?
It seems to shift harder, ...
Re: Transmission filter change
yes, sometimes the O-ring is tough to get in. it has to be squeezed in until it slips into a groove in the trans. that's the snap you probably felt taking the old one out. the o-ring coming out of the groove. sometimes installing the filter and either rocking or twisting the filter side to side (slightly) will help get the o-ring in. The filter is like a pick up for the trans. If the o-ring doesn't seal the suction that might pull from around the seal instead of through the filter.
Browse "SIMILAR TOPICS" At The Bottom Of This Page.
Re: Transmission filter change
instead of through the filter.
-
- Similar Topics
- Replies
- Views
- Last post
-
-
New post transmission not going into gear.
by woodrick » Sun Nov 01, 2015 7:28 am » in Dodge And Chrysler - 1 Replies
- 4086 Views
-
Last post by carriedi
Sun Nov 01, 2015 1:51 pm
-
-
- 5 Replies
- 14455 Views
-
Last post by carriedi
Sun Jul 08, 2018 5:03 pm
-
-
New post Dodge Transmission valve body question
by mylesd » Fri Jul 22, 2016 8:28 pm » in Dodge And Chrysler - 1 Replies
- 4354 Views
-
Last post by carriedi
Fri Jul 22, 2016 11:44 pm
-