resetting codes new speed sensor 98 mustang 3.8L 6 cylinder
resetting codes new speed sensor 98 mustang 3.8L 6 cylinder
A diagnostic scanner reported a bad speed sensor, so i replaced it with a new one. There was no improvement, and i was told the old codes needed to be deleted and allowed to reset. How is this done? No one seems to know and i havent been able to find any videos on youtube for it.
Re: resetting codes new speed sensor 98 mustang 3.8L 6 cylin
with the introduction of OBD2, it will usually take a scanner to clear the codes from memory.
What was the code you had before? What kind of improvement are you expecting to get? what is the problem with your car?
You start off describing the last part of your diag tree but I have no idea what you are trying to do.
What happened from the beginning? Did your "check engine" light come on or did you start having a driveability problem? Why did you scan for codes. What was the actual code numbers you pulled?
The more information I have the more informative answer I can give...
What was the code you had before? What kind of improvement are you expecting to get? what is the problem with your car?
You start off describing the last part of your diag tree but I have no idea what you are trying to do.
What happened from the beginning? Did your "check engine" light come on or did you start having a driveability problem? Why did you scan for codes. What was the actual code numbers you pulled?
The more information I have the more informative answer I can give...
Browse "SIMILAR TOPICS" At The Bottom Of This Page.
Re: resetting codes new speed sensor 98 mustang 3.8L 6 cylin
Simply unhook the ground cable off of The Ground Terminal on your battery for about 2 minutes and then the computer will be reset and codes will be cleared I have had to do this multiple times to get codes cleared after I have replaced parts( you will only have to do this one time each time you want to clear the old codes)
-
- Similar Topics
- Replies
- Views
- Last post
-
- 1 Replies
- 12001 Views
-
Last post by carriedi
Sun Jun 22, 2014 1:14 am
-
-
New post 04 mustang stall on take off and backfire
by pewkie1266 » Wed Jun 25, 2014 11:53 pm » in Ford Cars - 5 Replies
- 12616 Views
-
Last post by carriedi
Sat Oct 03, 2015 12:36 am
-
-
- 6 Replies
- 23396 Views
-
Last post by ribbonsam
Sat Feb 20, 2021 1:16 am
-
- 1 Replies
- 36244 Views
-
Last post by carriedi
Thu Aug 24, 2023 11:39 am
-
- 1 Replies
- 8925 Views
-
Last post by carriedi
Fri Apr 21, 2023 6:15 am