Monte Carlo Starting Procedure Delay
Monte Carlo Starting Procedure Delay
1999 Monte Carlo 3.1--hesitation between key turn and starter ignition--sometimes takes several key trys for connection with starter--starts and runs fine after starting. Auto parts store says alternator and battery check okay. What could be going out?
Re: Monte Carlo Starting Procedure Delay
your ignition switch sends power to fuse #7, 5Amp. then it goes to the neutral safety then to the starter relay under right side of the dash above the glove box. It is grounded by the theft deterrent module. You have to complete this side to the relay circuit to close the relay and send power to the starter solenoid.
you may have a security module problem if the ignition switch checks out ok
you may have a security module problem if the ignition switch checks out ok
Browse "SIMILAR TOPICS" At The Bottom Of This Page.
-
- Similar Topics
- Replies
- Views
- Last post
-
- 1 Replies
- 22739 Views
-
Last post by carriedi
Fri Jun 28, 2019 12:17 am
-
-
New post 2003 Monte Carlo 3.8 temperature and heater help needed
by den942 » Sat Jan 06, 2018 4:44 pm » in Chevy Cars - 3 Replies
- 26973 Views
-
Last post by carriedi
Fri Jan 12, 2018 12:05 pm
-
-
- 2 Replies
- 20654 Views
-
Last post by ivanhoe
Thu Feb 05, 2015 11:41 am