My 1998 Chevy Monte Carlo
3800 V6
tech = any
question = I'm looking for directions on how to program my keyless entry
for my 1998 Monte Carlo Z34 please help me






JK:
In the right side of the trunk, behind the side carpet trim, there is the   
programming connector. Ground that wire, the locks will lock then unlock t o
 verify it is in learn mode.  
Next, press and HOLD the lock and unlock button at the same time. The  
locks will lock then unlock to verify the remote has been learned.
Un ground the connector,  then test the remote  
2001 chevy malibu wont start, theft security light.
2004 cavalier abs trac off and service vehicle light on
Re-learn security codes after Passlock replaced 2003 impala
Added freon, cold on driver side, blows warm on pass side, now all warm
2001 trans has code P0753, no 1st gear, starts in 2nd. 1-2 shift solenoid
A few other Chevy questions.
2000 CHEVY MONTE CARLO
3800 V6
SERVICE ENGINE SOON
A SCAN FOUND NO OBD II CODES
Repairs done prior = ENGINE WAS CLEANED, FRONT HUB ASSEMBLIES  WERE CHANGED.

There are many different computer systems on todays cars. The service  ENGINE indicator is strictly
powertrain computer related. Service VEHICLE  codes are stored in the body control module. The service
VEHICLE indicator can be caused by several different systems. Anything from vehicle  lighting, to theft system,
to body control module(BCM) to ABS (but usually an ABS light as well), powertrain non-emissions related
codes, or  communications problems between any of these computers.
Most inexpensive scanners only read the powertrain computer. In order to  read codes that set a service
VEHICLE light ...
MORE